Licensed & insured • Free on-site estimates • Workmanship warranty
Dustless Hardwood Floor Refinishing
Clean, Dust-Controlled Demolition
We sand back to fresh wood using dustless technology, so the mess stays out of your home and your lungs.
Fresh stain, sealer, and finish that bring color and protection back to tired boards.
Seamless replacement of damaged or missing boards, blended into the surrounding floor.
We match existing tones or shift the color, with samples so there are no surprises.
We close unsightly gaps so the refinished floor is clean and even.
Careful restoration of older and original floors that protects their age and character.
We measure the floor, check board thickness and subfloor condition, and give you a clear written quote.
We seal off the work area and set up dust containment before a single sander touches the floor.
We sand back to fresh wood, replace failed boards, and fill gaps so the floor reads as one surface.
Color matched stain, two to three coats of commercial grade finish, then we walk the job with you.
Our sanding keeps fine dust contained, so restoration does not coat your whole house.
We restore character and historic floors rather than pushing you to rip them out.
Stain and board matches done with samples first, so the finished floor looks like one floor.
Every space is different, so we quote each job after seeing it. A few things shape the final number:
You get one clear, written estimate before any work starts. No deposit pressure, no guessing.
Honest numbers, because that’s the brand:
Scope
Typical installed range*
Subfloor leveling (when needed)
What moves the price most: how much prep the subfloor needs, wood species and grade, pattern complexity, and furniture/appliance handling. Beware of quotes that don’t mention prep. That cost shows up later, one way or another.
Most homes: 3–5 days of work plus finish cure time. Water-based finishes take light foot traffic in 24 hours and furniture in 3–4 days.
About 95–99% of dust is captured at the source. There's no dust cloud and no months of wiping surfaces; that's the practical difference.
Often, yes. Cupped boards that have dried flat can usually be sanded, and failed boards get replaced and blended into the surrounding floor. If water reached the subfloor, we address that first so the damage doesn't come back.
Yes. We sample stains on your actual floor, in your light, and you approve the match before we commit.
Solid hardwood: typically 4–6 times. Engineered hardwood: depends on wear-layer thickness. We measure it and tell you.
